XHS7C7 reamer head drive

Product selection instructions:

(1), XHSC hydraulic transmission allows working under high pressure.

(2) The maximum allowable pressure of the shell is 0.8MPa, if you have special requirements, please contact the manufacturer.

(3) Hydraulic oil: It is recommended to use high-quality, anti-foam, anti-oxidation mineral-based hydraulic oil. The ideal working oil temperature is 30°C~50°C, and the allowable oil temperature is -20°C~80°C. When the oil temperature is lower than 10°C , must use low-condensation hydraulic oil. The viscosity of the hydraulic oil is 40-60 centistokes, and the allowable value is 5-300 centistokes.

(4) The filter precision of hydraulic oil is recommended to be 25um or higher.

(5) The hydraulic transmission device can rotate in both directions, and the specific steering is shown in the attached drawing. If the user's requirement is opposite to that shown in the illustration, please specify when ordering.

(6) Positioning of oil drain pipe: XHSC transmission allows installation in any direction. In order to ensure the lubrication of each movement pair in the motor, it is required to fill the motor with hydraulic oil before working. Hydraulic oil.

(7) Selection of distributors: various hydraulic transmission devices can choose distributors of various specifications according to different working conditions. Consideration: Distributor installation: The direction of the inlet and outlet of the distributor is allowed to rotate at intervals of 72 degrees according to the shape of the installation connection position, but when the screw is loosened and rotated, be careful not to damage the sealing function of the flat O-ring.

Note: The XH hydraulic transmission device can be equipped with our company's XHM, XHS, XHGS, XHCA, XHBD and other motors according to the working conditions and service life to meet different customer needs.

    一个系统在宣布资金投入以前一般必须通过冲洗，冲洗的目标是要消除残余在系统内的污染物质、金属材料屑、化学纤维化学物质、铁芯等，在最开始两小时工作上，即使沒有彻底毁坏系统，也会造成一系列常见故障。因此高速液压柱塞马达需要按以下流程来清理系统油道：

    1）用一种易干的清理有机溶剂冲洗机油箱，再用通过过虑的气体消除有机溶剂沉渣。

    2）清理系统所有管路，一些情形下要把管路和接口开展预浸。

    3）在管路上装油滤，以维护阀的提供的油管路和工作压力管路。

    4)用冲洗板代替集流器上的电液伺服阀等高精度阀门。

    5）查验全部管路规格是不是适合，联接是不是恰当。如果系统中应用到电液伺服阀，我何不再多几句，液压阀得冲洗板要使液压油能从提供的油管路流入集流器，并立即回到机油箱，那样可以让液压油不断商品流通，以冲洗小型低速液压马达系统，让油滤滤除固态颗粒物，冲洗全过程中，没隔1～2个小时要检查一下油滤，防止油滤被污染物质阻塞，这时旁通不必开启，若是发觉油滤逐渐阻塞就立刻换油滤。