XHM31ZC5

Product selection instructions:

(1), XHSC hydraulic transmission allows working under high pressure.

(2) The maximum allowable pressure of the shell is 0.8MPa, if you have special requirements, please contact the manufacturer.

(3) Hydraulic oil: It is recommended to use high-quality, anti-foam, anti-oxidation mineral-based hydraulic oil. The ideal working oil temperature is 30°C~50°C, and the allowable oil temperature is -20°C~80°C. When the oil temperature is lower than 10°C , must use low-condensation hydraulic oil. The viscosity of the hydraulic oil is 40-60 centistokes, and the allowable value is 5-300 centistokes.

(4) The filter precision of hydraulic oil is recommended to be 25um or higher.

(5) The hydraulic transmission device can rotate in both directions, and the specific steering is shown in the attached drawing. If the user's requirement is opposite to that shown in the illustration, please specify when ordering.

(6) Positioning of oil drain pipe: XHSC transmission allows installation in any direction. In order to ensure the lubrication of each movement pair in the motor, it is required to fill the motor with hydraulic oil before working. Hydraulic oil.

(7) Selection of distributors: various hydraulic transmission devices can choose distributors of various specifications according to different working conditions. Consideration: Distributor installation: The direction of the inlet and outlet of the distributor is allowed to rotate at intervals of 72 degrees according to the shape of the installation connection position, but when the screw is loosened and rotated, be careful not to damage the sealing function of the flat O-ring.

Note: The XH hydraulic transmission device can be equipped with our company's XHM, XHS, XHGS, XHCA, XHBD and other motors according to the working conditions and service life to meet different customer needs.

    软氮化’含意并不是指得到的硬度比那些所谓的‘硬氮化’的硬度低，只是带有简单，方便，花费低的含意。

    软氮化：别名‘氮碳共渗’，初期把苏联（俄罗斯）的液态法汉语翻译为‘超低温氰化’。如今中国时兴的有汽体法，无（低）毒液态法和正离子法。渗透到钢表面的设计以‘氮’为主导，与此同时加上了‘碳’。碳的添加使表面化学物质层（白亮层）的产生和性能获得一些乃至是显著的改进。这儿要特别强调一下，和高频淬火不一样的地点是：氮碳共渗的核心点是期待得到一定薄厚（一般为10～20μm，也是有规定20μm之上的，小型液压马达厂家现阶段试验室里据悉在碳钢上以前到达的薄厚为110μm）硬度高，延性小，沒有或非常少松散等性能优质的白亮层，低速液压马达厂家对于次表面的蔓延层，依照钢种和应用规定不一样尽管有时候必须作一些调节，但处在主次影响力了。氮碳共渗的可用普遍，基本上遮盖全部常见钢种和生铁。